Name: Cisco SG350X-24
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Quality of Service

QoS Advanced Mode

363 Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x

STEP 5 DSCP In displays the DSCP value of the incoming packet that needs to be re-marked to an

alternative value. Select the DSCP Out value to indicate the outgoing value is mapped.

STEP 6 Click Apply. The Running Configuration file is updated with the new DSCP values.

Interface Settings

The Interface Settings page enables configuring QoS on each port of the device, as follows:

• QoS State Disabled on an Interface—All inbound traffic on the port is mapped to the

best effort queue and no classification/prioritization takes place.

• QoS State of the Port is Enabled—Port prioritize traffic on ingress is based on the

system wide configured trusted mode, which is either CoS/802.1p trusted mode or

DSCP trusted mode.

To enter QoS settings per interface:

STEP 1 Click Quality of Service > QoS Basic Mode > Interface Settings.

STEP 2 Select Port or LAG to display the list of ports or LAGs.

QoS State displays whether QoS is enabled on the interface.

STEP 3 Select an interface, and click Edit.

STEP 4 Select the Port or LAG interface.

STEP 5 Click to enable or disable QoS State for this interface.

STEP 6 Click Apply. The Running Configuration file is updated.

QoS Advanced Mode

This section covers the following topics:

•Overview

• Global Settings

• Out-of-Profile DSCP Mapping

Questions and Answers:

Need help?

Do you have a question about the Cisco SG350X-24 and is the answer not in the manual?

Cisco SG350X-24 Specifications

General