Cisco SG350X-24

IP Configuration
IPv6 Management and Interfaces
303 Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x
15
To define IPv6 neighbors:
STEP 1 Click IP Configuration > IPv6 Management and Interfaces > IPv6 Neighbors.
You can select a Clear Table option to clear some or all of IPv6 addresses in the IPv6
Neighbors Table.
• Static Only—Deletes the static IPv6 address entries.
• Dynamic Only—Deletes the dynamic IPv6 address entries.
• All Dynamic & Static—Deletes the static and dynamic address entries IPv6 address
entries.
The following fields are displayed for the neighboring interfaces:
• Interface—Neighboring IPv6 interface type.
• IPv6 Address—IPv6 address of a neighbor.
• MAC Address—MAC address mapped to the specified IPv6 address.
• Type—Neighbor discovery cache information entry type (static or dynamic).
• State—Specifies the IPv6 neighbor status. The values are:
- Incomplete—Address resolution is working. The neighbor has not yet responded.
- Reachable—Neighbor is known to be reachable.
- Stale—Previously-known neighbor is unreachable. No action is taken to verify its
reachability until traffic must be sent.
- Delay—Previously-known neighbor is unreachable. The interface is in Delay state
for a predefined Delay Time. If no reachability confirmation is received, the state
changes to Probe.
- Probe—Neighbor is no longer known to be reachable, and Unicast Neighbor
Solicitation probes are being sent to verify the reachability.
• Router—Specifies whether the neighbor is a router (Ye s or No).
STEP 2 To add a neighbor to the table, click Add.
STEP 3 Enter values for the following fields:
• Interface—The neighboring IPv6 interface to be added.
• IPv6 Address—Enter the IPv6 network address assigned to the interface. The address
must be a valid IPv6 address.