Security
RADIUS
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x 292
16
• Secret Key—Address of switch containing RADIUS client. Displays N/A if the Event
Type is Date/Time Change or Reset.
- Use default key—For specified servers, the device attempts to authenticate the
RADIUS client by using the existing, default Key String.
- Encrypted—To encrypt communications by using MD5, enter the key in encrypted
form.
- Plaintext—Enter the key string in plaintext mode.
STEP 5 Click Apply. The key for the device is updated in the Running Configuration file.
RADIUS Server Groups
To set up a group of users that will be using the device as its RADIUS server:
STEP 1 Click Security > RADIUS Server > RADIUS Server Groups.
STEP 2 Click Add and enter the following fields:
• Group Name—Enter a name for the group.
• Privilege Level—Enter the management access privilege level of the group.
• Time Range—Check to enable applying a time range to this group.
• Time Range Name—If Time Range is selected, select the time range to be used. Click
Edit to define a time range in the Time Range section. This field is only displayed if a
Time Range was previously created.
• VLAN—Select the VLAN for the users:
- None—No VLAN ID is sent.
- VLAN ID—VLAN ID sent.
- VLAN Name—VLAN name sent
STEP 3 Click Apply. The RADIUS group definition is added to the Running Configuration file of the
device.
To Next Page
Loading...
Need help?
General
