Cisco SG350X-24 User Manual

Security
Management Access Method
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x 304
16
STEP 5 Enter the Access Profile Name. This name can contain up to 32 characters.
STEP 6 Enter the parameters.
• Rule Priority—Enter the rule priority. When the packet is matched to a rule, user
groups are either granted or denied access to the device. The rule priority is essential to
matching packets to rules, as packets are matched on a first-match basis. The highest
priority is ‘1’.
• Management Method—Select the management method for which the rule is defined.
The options are:
- All—Assigns all management methods to the rule.
- Telnet—Users requesting access to the device that meets the Telnet access profile
criteria are permitted or denied access.
- Secure Telnet (SSH)—Users requesting access to the device that meets the SSH
access profile criteria, are permitted or denied access.
- HTTP— Users requesting access to the device that meets the HTTP access profile
criteria, are permitted or denied.
- Secure HTTP (HTTPS)—Users requesting access to the device that meets the
HTTPS access profile criteria, are permitted or denied.
- SNMP—Users requesting access to the device that meets the SNMP access profile
criteria are permitted or denied.
• Action—Select the action attached to the rule. The options are:
- Permit—Permits access to the device if the user matches the settings in the profile.
- Deny—Denies access to the device if the user matches the settings in the profile.
• Applies to Interface—Select the interface attached to the rule. The options are:
- All—Applies to all ports, VLANs, and LAGs.
- User Defined—Applies to selected interface.
• Interface—Enter the interface number if User Defined was selected.
• Applies to Source IP Address—Select the type of source IP address to which the
access profile applies. The Source IP Address field is valid for a subnetwork. Select one
of the following values:
- All—Applies to all types of IP addresses.
- User Defined—Applies to only those types of IP addresses defined in the fields.

Cisco SG350X-24 Specifications

General

Model	SG350X-24
Layer	Layer 3
Power Supply	Internal
Rack Mountable	Yes
RAM	512 MB
Flash Memory	256 MB
MAC Address Table	16K entries
Power over Ethernet (PoE)	No
Uplink Ports	4 x 10 Gigabit Ethernet
Jumbo Frame Support	Yes
Power Dedicated to PoE	Not applicable
Dimensions	440 x 44 x 350 mm
Stacking	Yes
Operating Temperature	0°C to 45°C
Storage Temperature	-20°C to 70°C
Relative Humidity	10% to 90% (non-condensing)
Power Consumption	30W (maximum)