Cisco SG500-28 Administration Guide

6
Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3 82
Administration: General Information
This section describes how to view system information and configure various
options on the device.
It covers the following topics:
• Device Models
• System Information
• Console Settings (Autobaud Rate Support)
• Rebooting the Device
• Routing Resources
• Monitoring Fan Status
• Defining Idle Session Timeout
• Pinging a Host
• Traceroute
Device Models
All models can be fully managed through the web-based switch configuration
utility.
NOTE Each model can be set to Layer 3 system mode by using the System Mode and
Stack Management page, except for the SG500X/ESW2-550X models that always
run in both Layer 2 and Layer 3 system mode.
When the device operates in Layer 3 system mode, the VLAN Rate Limit, and QoS
policers are not operational. Other QoS Advanced mode features are operational.
Only the SG500X/ESW2-550X models support Virtual Router Redundancy
Protocol (VRRP), and Routing Information Protocol (RIP).

Cisco SG500-28 Specifications

General

Ports	28
Port Type	Gigabit Ethernet
Layer	Layer 3
Switching Capacity	56 Gbps
PoE Support	No
Form Factor	Rack-mountable
RAM	256 MB
Flash Memory	32 MB
Power Supply	Internal
Jumbo Frame Support	9KB
VLAN Support	Yes
Operating Temperature	32°F to 113°F (0°C to 45°C)
Operating Humidity	10% to 90% non-condensing
Dimensions	17.3 x 10.2 x 1.7 in (440 x 260 x 44 mm)
MAC Address Table Size	16, 000 entries