18
Installing Your Phone
This chapter describes how to install your Cisco Small Business IP Phone and connect it to your
network. It contains the following sections:
Before You Begin
Before you install and connect your phone, verify with your system administrator (if applicable) that the
network is ready for the phone. Read the safety notices, and make sure you have all the phone parts
and documentation.
CAUTION Do not plug a telephone line cord into the port marked AUX. The RJ-11 port marked AUX is
reserved for connection with the Cisco Attendant Console. It is not for use as a telephone line port or
IP device connection.
Phone Connections
The phone connections are shown in Figure 1. Figure 1 Phone Connections
To Next Page
Loading...
Need help?
General
