EasyManuals Logo

Cisco SPA 504G User Manual

Cisco SPA 504G
74 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
32
Performing an Unattended (Blind) Transfer
To perform an unattended transfer for all phones (except the Cisco SPA501G)::
STEP 1
During an active call, press the bXfer softkey.
STEP 2 Enter the number to where you want to transfer the call. The call is transferred with no
further action required on your part.
Transferring a Held Call to an Active Call
If you have one call on hold and one active call, you can transfer one of the calls to the other call,
connecting the two callers. This is different from a conference call, because you no longer remain
part of the call after the transfer. (Not available for the Cisco SPA501G.)
With one active call and one or more calls on hold
:
Press the
xfer
softkey.
If you have only one call on hold, the call is transferred to the active party and you are
disconnected.
If you have more than one call on hold, choose the held call you want to transfer by pressing the
line button of the call on hold.

Table of Contents

Other manuals for Cisco SPA 504G

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco SPA 504G and is the answer not in the manual?

Cisco SPA 504G Specifications

General IconGeneral
Lines4
ProtocolsSIP, SPCP
SpeakerphoneYes
Ethernet Ports2 (10/100 Mbps)
Power over Ethernet (PoE)Yes
Voice CodecsG.711, G.726, G.729
Headset PortYes (2.5mm)
DisplayMonochrome LCD

Related product manuals