Using the web interface
System configuration is normally carried out through the web interface.
To use the web interface:
1. Open a browser window and in the address bar type either:
l the IP address of the system
l the FQDN of the system
2. Click Administrator Login.
(This step only applies if you are using "standalone FindMe" i.e. FindMe without Cisco TMSPE.)
3. Enter a valid administrator Username and Password and click Login (see the user accounts section for
details on setting up administrator accounts). You are presented with the Overview page.
Note that when logging in using the VCS web interface, you may receive a warning message regarding the
VCS's security certificate. This can safely be ignored.
A command line interface is also available.
Required fields
All mandatory fields on web pages are indicated by a red star .
Supported browsers
The VCS web interface is designed for use with Internet Explorer 8 or 9 (not in compatibility mode), Firefox 3
or later, or Chrome. Later versions of Internet Explorer may also work, but are not officially supported. It may
work with Opera and Safari, but you could encounter unexpected behavior.
JavaScript and cookies must be enabled to use the VCS web interface.
Cisco VCS Administrator Guide (X8.1.1) Page 18 of 507
Introduction
About this guide