Starter Pack provisioning
The VCS's Starter Pack Provisioning Server provides basic device provisioning, including phone book
support, for a range of endpoint device types without the need for Cisco TMS.
The Starter Pack option key must be installed to use basic device provisioning. It cannot be used in
combination with device provisioning managed through TMS. Note that the Starter Pack option key is
designed for single box deployments and is only available as a pre-configured factory setting.
Starter Pack
The Starter Pack is suitable for small enterprises. It provides basic VCS functionality and includes
Expressway and FindMe functionality automatically.
The following license restrictions apply by default:
n 50 registrations
n 5 traversal calls (extra traversal call license option keys can be added if required)
n 900 TURN relays
Note that:
n non-traversal calls are supported (a traversal license is used when one occurs)
n the Starter Pack has a maximum limit of 25 calls
When the Starter Pack option key is installed the Presence Server and FindMe are automatically enabled.
Configuring Starter Pack provisioning
The Provisioning page (Applications > Provisioning) is used to configure the VCS's Provisioning Server
when the VCS is running in Starter Pack mode.
The Starter Pack Provisioning Server provides basic device provisioning and is automatically enabled when
the Starter Pack option key is installed. It can be monitored on the Starter Pack status page.
Bandwidth limits
The Bandwidth limits section lists each supported device type and lets you choose whether or not to enable
the provisioning of bandwidth limits for that device. If you enable the bandwidth limits option for a device type
you can then configure the maximum incoming and outgoing bandwidth (in kbps) values to set on the
provisioned devices.
ClearPath
The ClearPath section lists each supported device type and lets you choose whether or not to enable the
provisioning of ClearPath for that device.
Provisioning users
To provision individual users, you must set up FindMe accounts. When you configure a FindMe account, you
can choose the devices to provision for that user. The FindMe account is also used to configure the user's
FindMe settings.
See VCS Starter Pack Express Deployment Guide for full details on setting up Starter Pack provisioning.
Cisco VCS Administrator Guide (X8.1.1) Page 258 of 507
Applications
Cisco TMS provisioning
To Next Page
Loading...
