Event Description Level
External Server
Communication
Failure
Communication with an external server failed unexpectedly. The Detail event
parameter should differentiate between "no response" and "request rejected". Servers
concerned are:
n DNS
n LDAP servers
n Neighbor Gatekeeper
n NTP servers
n Peers
1
FindMe Search
Failed
A search of the FindMe database has failed, for example due to no alias being provided. 1
Hardware
Failure
There is an issue with the VCS hardware. If the problem persists, contact your Cisco
support representative.
1
License Limit
Reached
Licensing limits for a given feature have been reached. The Detail event parameter
specifies the facility/limits concerned. Possible values for the detail field are:
n Non Traversal Call Limit Reached
n Traversal Call Limit Reached
If this occurs frequently, you may want to contact your Cisco representative to purchase
more licenses.
1
Message
Received
An incoming RAS message has been received. 2
Message
Received
An incoming RAS NSM Keepalive, H.225, H.245 or a RAS message between peers has
been received.
3
Message
Received
(SIP) An incoming message has been received. 4
Message
Rejected
This could be for one of two reasons:
n If authentication is enabled and an endpoint has unsuccessfully attempted to send a
message (such as a registration request) to the VCS. This could be either because
the endpoint has not supplied any authentication credentials, or because its
credentials do not match those expected by the VCS.
n Clustering is enabled but bandwidth across the cluster has not been configured
identically, and the VCS has received a message relating to an unknown peer, link,
pipe, subzone or zone.
1
Message Sent An outgoing RAS message has been sent. 2
Message Sent An outgoing RAS NSM Keepalive, H.225, H.245 or a RAS message between peers has
been sent.
3
Message Sent (SIP) An outgoing message has been sent. 4
Operator Call
Disconnect
An administrator has disconnected a call. 1
Outbound TLS
Negotiation
Error
The VCS is unable to communicate with another system over TLS. The event
parameters provide more information.
1
Package Install A package, for example a language pack, has been installed or removed. 2
Cisco VCS Administrator Guide (X8.1.1) Page 362 of 507
Reference material
About Event Log levels
To Next Page
Loading...
