Cisco TelePresence - Page 416

ID Title Description Solution Severity
40046 FIPS140-2
compliance
restriction
Clustered systems are not FIPS140-
2 compliant
Disband the cluster Warning
40048 Unified
Communications
configuration
error
Unified Communications services
are enabled but SIP TLS is disabled
Ensure that SIP TLS mode is set to
'On' on SIP configuration page
Warning
40100 Security alert Firewall rules are not synchronized
with network interfaces
Restart the system; if the problem
persists, contact your Cisco
representative
Warning
45001 Failed to load
Call Policy file
<failure details> Configure Call Policy Warning
45002 Configuration
warning
Expected default link between the
Default Subzone and the Default
Zone is missing
Configure default links Warning
45003 Configuration
warning
H.323 and SIP modes are set to Off;
one or both of them should be
enabled
Configure H.323 and/or SIP modes Warning
45004 Configuration
conflict
The FindMe mode is set to On or
Remote service but the FindMe
option key has been deleted
Reconfigure FindMe mode or
reinstall the option key
Warning
45005 Configuration
conflict
H323-SIP Protocol Interworking
mode is set to Registered only but
the H323-SIP Interworking Gateway
option key has been deleted
Reconfigure Interworking mode or
reinstall the option key
Warning
45006 Configuration
warning
Expected default link between the
Default Subzone and the Cluster
Subzone is missing
Configure default links Warning
45007 Configuration
warning
Expected default link between the
Default Subzone and the Traversal
Subzone is missing
Configure default links Warning
45008 Configuration
warning
Expected default link between the
Traversal Subzone and the Default
Zone is missing
Configure default links Warning
45009 Configuration
warning
For provisioning to work correctly,
authentication policy must be
enabled on the Default Zone and
any other relevant zone that
receives provisioning requests
Set authentication policy to either
'Check credentials' or 'Treat as
authenticated' for each relevant zone
Warning
45012 Configuration
warning
For Presence services to work
correctly, authentication policy must
be enabled on the Default Subzone
and any other relevant subzone;
authentication must also be enabled
on the Default Zone if the endpoints
are not registered
Set authentication policy to either
“Check credentials” or “Treat as
authenticated” for the Default
Subzone and each relevant subzone
and zone
Warning
Cisco VCS Administrator Guide (X8.1.1) Page 416 of 507
Reference material
Alarms