CheckPattern
A diagnostic tool that allows you to check the result of an alias transform (local or zone) before you configure it on the system.
Target(r): <S: 1, 60>
The alias you want to use to test the pattern match or transform.
Pattern(r): <S: 1, 60>
The pattern against which the alias is compared.
Type(r): <Exact/Prefix/Suffix/Regex>
How the pattern string must match the alias for the pattern behavior to be applied.
Behavior(r): <Strip/Leave/Replace/AddPrefix/AddSuffix>
How the alias is modified.
Replace: <S: 0, 60>
The text string to use in conjunction with the selected Pattern behavior.
Example: xCommand CheckPattern Target: "bob@a.net" Pattern: "@a.net" Type: "suffix" Behavior: replace
Replace: "@a.com"
ClearAllStatus
Clears all status and history on the system.
Example: xCommand ClearAllStatus
Cucmconfigadd
Performs a lookup on a Unified CM publisher.
Address(r): <Value>
The FQDN or IP address of the Unified CM publisher.
Axlpassword(r): <Value>
The password used by the VCS to access the Unified CM publisher.
Axlusername(r): <Value>
The user name used by the VCS to access the Unified CM publisher.
CertValidationDisabled: <On/Off>
Controls X.509 certificate checking against the certificate presented by the Unified CM publisher. Default: On
Example: xCommand Cucmconfigadd Address: "cucm.example.com" Axlpassword: "xyz" Axlusername: "abc"
Cucmconfigdelete
Deletes the details of a Unified CM publisher.
Address(r): <Value>
The FQDN or IP address of the Unified CM publisher.
Example: xCommand Cucmconfigdelete Address: "cucm.example.com"
DefaultLinksAdd
Restores links between the Default Subzone, Traversal Subzone and the Default Zone.
This command has no parameters.
Example: xCommand DefaultLinksAdd
Cisco VCS Administrator Guide (X8.1.1) Page 472 of 507
Reference material
Command reference — xCommand
To Next Page
Loading...
