Cisco UCS 6248 UP - SFP Transceivers; SFP+ Copper Cables

DescriptionCisco SFP
GE SFP, LC connector LX/LH transceiver (SMF),
extended temperature range and DOM
SFP-GE-L
4-Gbps Fibre Channel SW SFP, LC (for FC
configured Unified ports)
DS-SFP-FC4G-SW
4-Gbps Fibre Channel LW SFP, LC (for FC
configured Unified ports)
DS-SFP-FC4G-LW
8-Gbps Fibre Channel SW SFP+, LC(for FC
configured Unified ports)
DS-SFP-FC8G-SW
8-Gbps Fibre Channel LW SFP+, LC (for FC
configured Unified ports)
DS-SFP-FC8G-LW
The maximum length of fiber optic runs is limited to 300 meters. This is imposed by our use of
802.3X/802.1Qbb Priority Pauses. SFP-10G-LR is supported between fabric interconnect and FEX, but the
300 m limit still applies.
Note
SFP Transceivers
The SFP 1 -Gigabit Ethernet transceiver module is a bidirectional device with a transmitter and receiver in
the same physical package.
Table 7: Supported SFP Optical Transceivers
DescriptionModel
1-Gigabit Ethernet copper SFP moduleGLC-T
1-Gigabit Ethernet—short range (550m max) SFP
module
GLC-SX-MM
1-Gigabit Ethernet—long range (10km) SFP moduleGLC-LH-SM
The maximum length of fiber optic runs is limited to 300 meters. This is imposed by our use of
802.3X/802.1Qbb Priority Pauses. SFP-10G-LR is supported between fabric interconnect and I/O Module,
but the 300 m limit still applies.
Note
SFP+ Copper Cables
Copper cables are available for use with the 10-Gigabit Ethernet SFP+ module.
Cisco UCS 6200 Series Fabric Interconnect Hardware Installation Guide
15OL-24475-03
Product Overview
SFP Transceivers