Cisco UCS 6248 UP - Transceiver Specifications; Environmental Conditions and Power Requirement Specifications for SFP+ Transceivers

Table 17: Specifications for theCisco UCS 6296750W Power Supply (N10-PAC2-750W=)
SpecificationDescription
90 to 264 VACAC-input voltage
50 to 60 Hz nominal (Range: 47 to 63 Hz)AC-input frequency
9.2 Amps @ 90 VACAC-input current
828 VA @ 90 VACMaximum Input VA
750 W @ 12 VDC (up to two power supplies)Maximum output power per power supply
35 A <sub cycle durationMaximum inrush current
2561 BTU/hrMaximum Heat Output
12 msMaximum hold up time
12 VDCPower supply output voltage
89% (Climate Savers Gold qualified)Efficiency Rating
Transceiver Specifications
Table 18: General Specifications for the 10-Gigabit Ethernet SFP+ Transceiver Module
Short RangeDescription
LCConnector type
850 nmWavelength
62.5 microns—33 m
50 microns—300 mCore size—Cable distance
Further specifications for these transceivers are at this URL:
http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/installation/note/78_15160.html
Environmental Conditions and Power Requirement Specifications for SFP+
Transceivers
Table 19: Environmental Conditions and Power Requirement Specifications for the 10-Gigabit Ethernet SFP+ Transceiver Module
MaximumMinimumSymbolParameter
85°C (185°F)-40°C (-40°F)TSStorage temperature
70°C (158°F)0°C (32°F)TCCase temperature
Cisco UCS 6200 Series Fabric Interconnect Hardware Installation Guide
69OL-24475-03
Technical Specifications
Transceiver Specifications