Cisco WS-C2950-12 User Manual

Chapter 2 Installation
Preparing for Installation
2-8
Catalyst 2950 Desktop Switch Hardware Installation Guide
78-11157-03
• Mounting kit containing these items:
– Four rubber feet for mounting the switch on a table, shelf, or desk
– Two 19-inch or 24-inch rack-mounting brackets
– Six number-8 Phillips flat-head screws for attaching the brackets to the
switch
– Four number-8 Phillips truss-head screws for attaching the brackets to
the switch
– Four number-12 Phillips machine screws for attaching the brackets to a
rack
– One cable guide and one black Phillips machine screw for attaching the
cable guide to one of the mounting brackets
• DC-switch kit containing these items:
– One DC terminal block plug (also called a terminal block header)
– One ground lug
– Two number-10-32 screws for attaching the ground lug to the switch
– Two 23-inch rack-mounting brackets (with 1-inch spacing for telco
racks)
– Four number-8 Phillips truss-head screws for attaching the brackets to
the switch
– Two number-12 Phillips machine screws for attaching the brackets to a
rack
Note The DC-switch kit ships only with the Catalyst 2950G-24-EI-DC switch.
• One RJ-45-to-DB-9 adapter cable
• Cisco Information Packet, containing safety and support information
If you want to connect a terminal to the switch console port, you need to provide
an RJ-45-to-DB-25 female DTE adapter. You can order a kit (part number
ACS-DSBUASYN=) with that adapter from Cisco.

Cisco WS-C2950-12 Specifications

General

Brand	Cisco
Model	WS-C2950-12
Category	Switch
Language	English