Cisco XR 12000 Series Getting Started Guide

5-110
Cisco IOS XR Getting Started Guide for the Cisco XR 12000 Series Router
OL-24755-01
Chapter 5 CLI Tips, Techniques, and Shortcuts
Wildcards, Templates, and Aliases
crc 32
!
keepalive disable
--More--
The following example shows how the state of all POS interfaces is displayed:
RP/0/0/CPU0:router# show interfaces pos* brief
Intf Intf LineP Encap MTU BW
Name State State Type (byte) (Kbps)
--------------------------------------------------------------------------------
PO0/1/0/0 up up HDLC 4474 2488320
PO0/1/0/1 up up HDLC 4474 2488320
PO0/1/0/2 up up HDLC 4474 2488320
PO0/1/0/3 up up HDLC 4474 2488320
PO0/1/0/4 up up HDLC 4474 2488320
PO0/1/0/5 up up HDLC 4474 2488320
PO0/1/0/6 up up HDLC 4474 2488320
PO0/1/0/7 up up HDLC 4474 2488320
PO0/1/0/8 up up HDLC 4474 2488320
PO0/1/0/9 up up HDLC 4474 2488320
PO0/1/0/10 up up HDLC 4474 2488320
PO0/1/0/11 up up HDLC 4474 2488320
PO0/1/0/12 up up HDLC 4474 2488320
PO0/1/0/13 up up HDLC 4474 2488320
PO0/1/0/14 up up HDLC 4474 2488320
PO0/1/0/15 up up HDLC 4474 2488320
Creating Configuration Templates
Configuration templates allow you to create a name that represents a group of configuration commands.
After a template is defined, it can be applied to interfaces by you or other users. As networks scale to
large numbers of nodes and ports, the ability to configure multiple ports quickly using templates can
greatly reduce the time it takes to configure interfaces.
The two primary steps in working with templates are creating templates and applying templates. The
following procedure describes how to create a configuration template.
SUMMARY STEPS
1. configure
2. template template-name [($parameter $parameter...)] [config-commands]
3. Enter the template commands.
4. end-template
5. commit
6. show running-config template template-name

Cisco XR 12000 Series Specifications

General

Brand	Cisco
Model	XR 12000 Series
Category	Network Router
Language	English