Cisco XR 12000 Series Getting Started Guide

5-113
Cisco IOS XR Getting Started Guide for the Cisco XR 12000 Series Router
OL-24755-01
Chapter 5 CLI Tips, Techniques, and Shortcuts
Wildcards, Templates, and Aliases
In the next example, a template with one parameter is applied and the show configuration command
displays the result:
RP/0/0/CPU0:router# configure
RP/0/0/CPU0:router(config)# apply-template test2 (router)
RP/0/0/CPU0:router(config)# show configuration
Building configuration...
hostname router
end
Aliases
With the Cisco IOS XR software, you can define command-line aliases for any physical or logical entity
in a router. After you define the alias, it is used in the CLI to reference the real entity.
To create a command alias, enter the alias command in global configuration or administration
configuration mode:
alias alias-name [(parameter1 parameter2...)] command-syntax [$parameter1] command-syntax
[$parameter2]
Table 5-5 defines the alias command syntax.
Multiple commands can be supported under a single command alias, and multiple variables can be
supported for each command. If multiple commands are specified under a single alias, each command is
executed in the order in which it is listed in the alias command.
In the following example, an alias named my-cookie is created for the Management Ethernet interface,
and then the new alias is specified to enter interface configuration mode:
RP/0/0/CPU0:router(config)# alias my-cookie mgmtEth 0/0/CPU0/0
RP/0/0/CPU0:router(config)# interface my-cookie
RP/0/0/CPU0:router(config)# interface mgmtEth 0/0/CPU0/0
RP/0/0/CPU0:router(config-if)#
After you enter a command with an alias, the router displays the command you entered with the alias
value so that you can verify that alias value.
To delete a specific alias, enter the no form of the alias command with the alias name.
Table 5-5 alias Command Syntax
Syntax Specifies that the Alias Is Created for
alias-name Name of the command alias. An alias name can be a single word or
multiple words joined by a dash (–) delimiter.
command-syntax Original command syntax. Valid abbreviations of the original
command syntax can be entered for the command-syntax argument.
(parameterx) Argument or keyword that belongs to the command you specified for
the command-syntax argument. When the parameter is entered in
parenthesis after the alias name, the alias requires a parameter name.
To associate the parameter with a command within the alias, enter the
$ character preceding the parameter name.

Cisco XR 12000 Series Specifications

General

Brand	Cisco
Model	XR 12000 Series
Category	Network Router
Language	English