Cisco XR 12000 Series

3-43
Cisco IOS XR Getting Started Guide for the Cisco XR 12000 Series Router
OL-24755-01
Chapter 3 Configuring General Router Features
Navigating the Cisco IOS XR Command Modes
User group 'root-system' has the following combined set
of task IDs (including all inherited groups):
Task: aaa : READ WRITE EXECUTE DEBUG
Task: acl : READ WRITE EXECUTE DEBUG
Task: admin : READ WRITE EXECUTE DEBUG
Task: ancp : READ WRITE EXECUTE DEBUG
Task: atm : READ WRITE EXECUTE DEBUG
Task: basic-services : READ WRITE EXECUTE DEBUG
Task: bcdl : READ WRITE EXECUTE DEBUG
Task: bfd : READ WRITE EXECUTE DEBUG
Task: bgp : READ WRITE EXECUTE DEBUG
Task: boot : READ WRITE EXECUTE DEBUG
Task: bundle : READ WRITE EXECUTE DEBUG
Task: cdp : READ WRITE EXECUTE DEBUG
Task: cef : READ WRITE EXECUTE DEBUG
Task: cgn : READ WRITE EXECUTE DEBUG
Task: config-mgmt : READ WRITE EXECUTE DEBUG
Task: config-services : READ WRITE EXECUTE DEBUG
Task: crypto : READ WRITE EXECUTE DEBUG
Task: diag : READ WRITE EXECUTE DEBUG
Navigating the Cisco IOS XR Command Modes
The Cisco IOS XR Software has different command modes. Each mode provides access to a subset of
commands used to configure, monitor, and manage the router. Access to a mode is determined by your
user group assignments. The following sections describe the navigation of the command modes:
• Identifying the Command Mode in the CLI Prompt, page 3-44
• Summary of Common Command Modes, page 3-45
• Entering EXEC Commands from a Configuration Mode, page 3-47
• Command Mode Navigation Example, page 3-48
Figure 3-4 illustrates the basic command mode navigation for the CLI. Only a small sample of the
possible configuration modes is shown.