Cisco XR 12000 Series - Page 91

4-79
Cisco IOS XR Getting Started Guide for the Cisco XR 12000 Series Router
OL-24755-01
Chapter 4 Configuring Additional Router Features
Configuring Telnet, HTTP, and XML Host Services
Step 4
end
or
commit
Example:
RP/0/0/CPU0:router(config)# end
or
RP/0/0/CPU0:router(config)# commit
Saves configuration changes.
• When you issue the end command, the system prompts
you to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
– Entering yes saves configuration changes to the
running configuration file, exits the configuration
session, and returns the router to EXEC mode.
– Entering no exits the configuration session and
returns the router to EXEC mode without
committing the configuration changes.
– Entering cancel leaves the router in the current
configuration session without exiting or
committing the configuration changes.
• Use the commit command to save the configuration
changes to the running configuration file and remain
within the configuration session.
Step 5
exit
Example:
RP/0/0/CPU0:router(config)# exit
Exits global configuration mode.
Step 6
configure
Example:
RP/0/0/CPU0:router# configure
Enters global configuration mode.
Step 7
telnet ipv4 server max-servers limit
or
telnet ipv6 server max-servers limit
Example:
RP/0/0/CPU0:router(config)# telnet ipv4 server
max-servers 5
Enables Telnet services on the router and specifies the
maximum number of allowable Telnet servers.
Step 8
http server
Example:
RP/0/0/CPU0:router(config)# http server
Enables HTTP server on the router.
Command or Action Purpose