Clarion NX700 - Entering an Address if House Numbering Is Restarted

34
3.1.2.2 Entering an address if house numbering is restarted
There are long roads where house numbering is restarted at some point. This way the same house
number can appear twice or even more times on the same road. If this is the case, after entering the
house number, you need to select the appropriate address by the district/suburb information.
The procedure is explained starting from the Navigation menu.
1. Tap the following buttons:
(Simple mode), or , (Advanced mode).
2. By default, Clarion Mobile Map proposes the country/state and city where you are. If needed, tap
the button with the name of the country/state, and select a different one from the list.
3. If needed, change the city:
x To select the city from the list of recently used ones, tap the
button.
x To enter a new city:
1. Tap the button with the name of the city, or if you have changed the country/state,
tap
.
2. Start entering the city name on the keyboard.
3. Get to the list of search results:
x After entering a couple of characters, the names that match the string appear
in a list.
x Tap
to open the list of results before it appears
automatically.
4. Select the city from the list.
4. Enter the street name:
1. Tap
.
2. Start entering the street name on the keyboard.
3. Get to the list of results:
x After entering a couple of characters, the names that match the string appear in a list.
x Tap
to open the list of results before it appears automatically.
4. Select the street from the list.
5. Enter the house number:
1. Tap
.