EasyManua.ls Logo

Clear-Com TEMPEST 2400 - Accessory Items You May Require

Clear-Com TEMPEST 2400
108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11 Tempest®2400 2-Channel Wireless Intercom System
Accessory Items You May Require
Headsets
A Headset is required for each user (XLR-4F connectors).
Headsets may use Electret or Dynamic microphones. Most major brand headsets
that have the correct XLR-4F connector should be compable, requiring nothing
more than a simple Mic Gain adjustment.
DC Power Input Cable
To power the Tempest BaseStaon via DC power (Baery) instead of AC power, you will need to provide a DC Power
input Cable.
RF Cable to Remote Antennas
If you plan to remotely locate your antennas to improve antenna posioning and maximize range, you must provide
high quality 50 ohm RF cables with RP-TNC connectors.
CAT-5 Cable for Remote Transceiver
If you plan to locate the Remote Transceiver more than 15 feet from the Tempest BaseStaon, you will need to
provide a longer CAT-5 cable. The maximum CAT-5 cable length recommended is 1,500 feet.
BaseSync DE-9 Cable(s)
If you use mulple BaseStaons to use Accu-Sync BaseStaon synchronizaon, you will need to provide one Accu-Sync
DE-9 cable per addional BaseStaon. You cannot sync Tempest 2.4 GHz and 900 MHz models together.
Connecons to the Hard wired Intercom
XLR-3M/F for 2-Wire
If you plan to connect the Tempest BaseStaon to external 2-Wire party-line intercom systems, you will need to
provide the appropriate 3-PIN XLR cabling.
RJ-45 Connector Cable for 4-Wire
If you plan to connect the Tempest BaseStaon to external Clear-Com 4-Wire intercom systems, you will need to
provide the appropriate cabling.
RJ-45 to RJ-12 Adapter
If you plan to connect to an RTS 4W system, you will need adapters.
Auxiliary IN/OUT ¼” Tip/Ring/Sleeve Cable
If you plan to connect the Tempest BaseStaon to external audio devices via the Auxiliary IN and/or the Auxiliary OUT
connectors, you will need to provide the appropriate balanced ¼” TRS cabling.
Stage Announce XLR-3F Cable
If you plan to connect the Tempest BaseStaon to an external audio device via the Stage Announce connector, you will
need to provide the appropriate XLR-3F cabling.
Relay Access DA-15 Breakout Cable
If you plan to ulize any of the six available relays on the back of the Tempest BaseStaon, you will need to provide an
appropriate DA-15 breakout cable to access the Stage Announce Relay and Individual Relays.
LAN Connecon RJ-45 / CAT-5 Cable
If you plan to connect the Tempest BaseStaon to a computer or local area network, you will need to provide the
appropriate RJ-45 CAT-5 cabling.

Table of Contents

Other manuals for Clear-Com TEMPEST 2400

Related product manuals