EasyManua.ls Logo

Clear-Com TEMPEST 2400 - Battery Selection and Installation; Steps to Setup the Beltstations

Clear-Com TEMPEST 2400
108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
42 Tempest®2400 2-Channel Wireless Intercom System
BeltStaon Setup
Steps to Setup the BeltStaons
Install the baery.
“Pair” BeltStaons to the BaseStaon.
Adjust slot sengs as needed.
Connect a headset.
Adjust Mic Gain.
Adjust Sidetone.
Congure oponal features:
» Name the BeltStaon.
» Disable unused funcons, channels, and buons.
» Select/disable relay opons as needed.
» Adjust personal preferences.
Baery Selecon and Installaon
The Tempest BeltStaon Baery Compartment holds either one Tempest Lithium-Polymer rechargeable baery or three
standard alkaline AA cells. Lithium-Polymer baeries are the primary power source. High quality alkaline AA cells may be
used in situaons where Lithium-Polymer baeries are not available or are not charged. One Lithium-Polymer baery
comes standard with each Tempest BeltStaon. Addional Lithium-Polymer baeries may be purchased. Contact your
dealer or distributor to purchase addional baeries. The Lithium-Polymer baeries supplied with your Tempest Wireless
system are warranted for 12 months from the date of purchase.
Lithium-Polymer baeries oer up to nine hours of baery life and recharge in
approximately 2¾ hours.
Lithium-Polymer baeries ship from the factory with approximately 50% charge. It
will not damage the Lithium-Polymer baeries to use them without charging them
rst. This will, however result in shorter run me unl the Lithium-Polymer baery
is fully charged. When possible, charge Lithium-Polymer baeries to full capacity to
ensure full baery life prior to use.
Using (3) alkaline AA baeries can provide up to four hours of baery life. Use
only high quality alkaline AA cells. This will provide enough me to fully charge the
Lithium-Polymer baery.
To remove the baery door, press down on the thumb markings and pull the baery door toward the boom of the
BeltStaon.
To remove baeries from the baery compartment, turn the BeltStaon baery side down and tap the boom of the
BeltStaon on the palm of your other hand.
Please be careful to insert alkaline AA baeries according to the marked polarity. All of the alkaline AA cells must be
oriented the same direcon.
If the baery cover does not close properly, the baery may not be inserted correctly.

Table of Contents

Other manuals for Clear-Com TEMPEST 2400

Related product manuals