Clear-Com TEMPEST 2400 - Beltstation

76 Tempest®2400 2-Channel Wireless Intercom System
BeltStaon
BeltStaon will not power up
• Conrm that baery(ies) is (are) installed correctly.
• When using a Lithium-Polymer rechargeable baery, ensure that the baery is fully charged.
• When using alkaline AA baeries, ensure that baeries are fresh and are all facing the same way. Note the illustraon
in the baery compartment secon.
• Press and hold the Power buon on the back of the BeltStaon for two seconds to power ON.
BeltStaon will not pair with BaseStaon
• Conrm that the BaseStaon you are pairing with is powered ON and in Operaonal Mode, and the BeltStaon is
powered OFF. Connect the pairing cable from the BaseStaon to the BeltStaon. Turn the BeltStaon power ON.
The pairing process takes approximately four seconds.
• If pairing is successful, the message “Pairing Complete” will appear on the BeltStaon LCD for approximately ve
seconds and the BeltStaon name will appear in the rst available slot on the BaseStaon LCD. The BaseStaon
name will appear on the BeltStaon LCD. If pairing is not successful no message will appear.
• If pairing is not successful, try to pair a dierent BeltStaon with the BaseStaon. If neither of the BeltStaons
will pair, substute a new Pairing cable.
• If successful pairing any BeltStaon with the BaseStaon, try the following procedure on the BeltStaon that will
not pair:
» Restore memory sengs to Factory Defaults by pressing MENU
» Select “Belt Sengs,” select “Tech Menu,” press ENTER to proceed
» Select “Set Defaults,” select Restore Factory Defaults, press ENTER to conrm and press MENU to exit
• If sll not successful, repeat the above procedure but select Clear Memory to delete all memory sengs, pairings,
and user sengs. See “Factory Defaults” secon for more detail.
• If no BeltStaon will pair with the BaseStaon, reset the BaseStaon memory to “Factory Defaults”.
• The nal opon is to select “Clear Memory” to fully reset the BaseStaon. All BeltStaon pairings will be lost with the
“Clear Memory” opon. See “Factory Defaults” secon for more detail.
BeltStaon will not log into BaseStaon
• Conrm that the BeltStaon is powered ON and has a baery with ample charge.
• Conrm that the proper BaseStaon is selected on the BeltStaon’s “Select Base” menu.
• Conrm that there is an available slot on the BaseStaon.
• Check Stac and Dynamic slot display sengs on the BaseStaon. If Stac is selected check the BeltStaon slot
assignment.
• Determine if any BeltStaon is logged onto the BaseStaon.
• Re-pair the BeltStaon to the BaseStaon.
• Aempt to log into another BaseStaon, if available.
• Follow the memory reset procedure under “Factory Defaults.”