EasyManua.ls Logo

Clear-Com TEMPEST 2400 - Tempest Remote Transceiver

Clear-Com TEMPEST 2400
108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
77 Tempest®2400 2-Channel Wireless Intercom System
Buons on the BeltStaon do not funcon
A number of buons on the BeltStaon can have alternate funcons that the user can select.
If a buon on the BeltStaon is not working as expected, re-conrm all sengs and any alternate funcon assignment
in the menu. The buon may have been reassigned wirelessly from the BaseStaon or by T-Desk. Conrm that the
funcon is available for use. If the reassignment involves any GPO, conrm that menu selecon, the connecons, and
the equipment funconality.
Call Funcon does not work properly
Check to make sure that the CALL funcon is enabled.
Conrm that a TALK buon is enabled for the channel that you wish to call.
A Call signal will be received by the BeltStaon only on the channel(s) that are currently being monitored.
Stage Announce (SA) funcon does not work properly
The Stage buon has two separate funcons. Oponally, it controls the shared Stage relay contact on the back of the
BaseStaon.
» When you press the STAGE buon it reroutes the BeltStaon users microphone to the SA output on the back of
the BaseStaon.
» When pressing the STAGE buon, if there is no audio present at the SA, conrm that the Stage Announce
funcon is enabled in the BeltStaon.
» If the SA relay does not close, ensure that the Stage Relay is enabled in the BeltStaon. If problems persist,
conrm the operaon with another BeltStaon.
Tempest Remote Transceiver
Remote Transceiver RX or TX LEDs do not light
While the Transceiver is properly connected to the BaseStaon, turn the BaseStaon Power Switch to the OFF posion.
Wait for 30 seconds and turn the BaseStaon Power Switch back to the ON posion. This should inialize the Remote
Transceiver. The Cong LED should light momentarily and then go out. Once the Cong LED goes out the Remote Transceiver
TX LED should light. If there are BeltStaons communicang to the BaseStaon through the Remote Transceiver the RX LED
should light as well.
When connecng any shared BaseStaons to any wired intercom system,
only channels connected to the wired system can be shared. A BeltStaon
CALL signal is sent only when the Talk buon is enabled.
To manually re-inialize the Transceiver, power OFF the BaseStaon for at least
15 seconds and power the BaseStaon back ON, with the Transceiver connected.

Table of Contents

Other manuals for Clear-Com TEMPEST 2400

Related product manuals