EasyManua.ls Logo

Clear-Com TEMPEST 2400 - Update the Firmware (with Codeupdater)

Clear-Com TEMPEST 2400
108 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
73 Tempest®2400 2-Channel Wireless Intercom System
Update the Firmware (with CodeUpdater)
Tempest rmware updates are released periodically,
and equipment should be updated to maximize
opmal system performance. Staying up to
date with the latest rmware ensures that your
system is equipped with the newest features and
enhancements that Tempest has to oer.
Tempest uses a proprietary program, CodeUpdater,
to update rmware in the BaseStaon and the
BeltStaon. Tempest CodeUpdater can automacally
detect what rmware is currently installed on a unit
and indicate whether a later version is available. Note:
You must have internet access on your PC for CodeUpdater to
accurately detect the latest released versions available.
Connecng Your BeltStaon for Updang:
Be sure the BeltStaon is powered OFF.
Plug in your USB programming cable to your computer rst.
Push and hold the CALL buon on the front of the BeltStaon and plug in the USB cable to the side USB-A
connector on the BeltStaon. The BeltStaon will power ON automacally. Do not release the CALL buon unl
the BeltStaon display message appears.
Connecng Your BaseStaon for Updang:
Be sure the BaseStaon is powered OFF.
Plug in your USB programming cable to your computer and into the front USB-B on the BaseStaon.
Push and hold the MIC KILL buon on the BaseStaon front panel and then power ON. Do not release the MIC
KILL buon unl the BaseStaon display message appears.
Updang Firmware:
Open Tempest CodeUpdater on your PC.
Connect the device. CodeUpdater will list the model of the equipment connected next to device.
You may be prompted to update Bootloader rmware. If so, it is highly recommended that you do update it.
When updang the Bootloader, it is very important that you not interrupt the update. Be sure USB cable is
securely connected before starng the upgrade process. Interrupng the update may require the device to be
returned to the factory for re-programming. It is highly recommended that you not use a wireless connecon
when updang the Bootloader. Note: If you update the Bootloader you will have to re-connect your device to inialize the
process again.
The “Current Version” of rmware will display in CodeUpdater along with the “Latest Version” available (if
applicable). Note: The PIC rmware version is only applicable to the BaseStaon rmware.
If an update is available check the box under “Upgrade Selecon” and click the <Upgrade> buon.
Repeat these steps as needed for each Tempest unit.

Table of Contents

Other manuals for Clear-Com TEMPEST 2400

Related product manuals