Clear-Com TEMPEST 2400 - Quick Start Guide; What You will Need

6 Tempest®2400 2-Channel Wireless Intercom System
Quick Start Guide
What You Will Need
BaseStaon
» Power cord
» One BaseStaon antenna
» 3.5mm male-to-male mini-stereo
pairing cable
BeltStaons
» Up to 5 per BaseStaon
» Lithium-Polymer baery and
» Charger - 1 per BeltStaon
Headsets (customer supplied)
» 1 per BeltStaon
» 1 per BaseStaon
1. Connect a whip antenna onto the back of the BaseStaon.
Select a suitable locaon for the BaseStaon. Tempest is a radio system, broadcasng and receiving RF signals that are
aected by physical and electronic barriers.
The antenna should be located as high as possible and away from all
obstrucons. When using a whip (omnidireconal) antenna, select a
locaon as close as possible to the center of the area you want to cover.
Use alternave antenna opons when the BaseStaon is in a rack or other
metal structure, or stacked with other gear. Remote locaon antenna
placement of up to 1,500 . can be achieved using the Tempest Remote
Transceiver. See the user manual for more details about antenna placement,
recommended cable types, and other antenna opons.
2. Connect the power cord and Power On the BaseStaon.
3. Install Baeries in BeltStaons
Install the Lithium-Polymer baery in each BeltStaon. Be certain that the gold
contacts on the baery touch the contacts in the baery compartment. The baery
is shipped with a paral charge, so charging will be necessary before maximum run
me will be achieved.
OR
Insert (3) AA alkaline baeries in the baery compartment. Always replace the
baery cover.
To power ON the BeltStaon, press and hold the power buon for approximately
two seconds. The display will indicate “None Selected.” Turn the power OFF by
holding the power buon for four seconds.