Clear-Com TEMPEST 2400 Reference Manual

47 Tempest®2400 2-Channel Wireless Intercom System
Set Mic Gain
Set the Mic Gain properly to ensure the best audio quality. To set the Mic Gain for the BeltStaon Headset:
1. Press MENU to enter Menu Mode. From the Main Menu, select “Set Controls,” then “Mic Gain.”
2. While at the Mic Gain screen, talk into the headset microphone at a louder than normal level and adjust the Volume control
unl the PEAK LEDs just start to light at the loudest parts of the audio. Press ENT to accept the changes.
Mic Gain can be set in the BeltStaon without acvang the Talk buon. This allows private mic gain adjustment during live
events. The Mic Gain can be set for each BeltStaon from the T-Desk applicaon.
When the Mic Gain is set too high, it is possible to induce feedback or echo. When set too low, words can be clipped by
the low level noise gate or sound too quiet to other listeners. Headsets by dierent manufacturers or dierent models
of headsets will require widely varying Mic Gain sengs. When seng microphone gain, it is best to err toward a seng
that is too low, rather than too high. This will help reduce unwanted echo in the system when that microphone is enabled.
Either/Or
The Either/Or feature only applies to 2-Channel BeltStaons working in Dual Listen mode. With the Either/Or funcon,
a BeltStaon user can hear both channels, but only talk on one channel at a me. By default, the “Talk” buon is acve;
therefore, the “Talk” buon only serves as a method to change the channel. By tapping the “Talk A” buon, the acve
“Talk” channel becomes “A”; by tapping the “Talk B” buon, the acve “Talk” channel becomes “B.” Since the “Talk” is
always ON, the BeltStaon has two ways to mute: (1) to mute momentarily, press and hold the “Talk” buon on the acve
talk channel and then release to end mute, (2) to latch the mute funcon, double-tap the acve talk channel; tap (once)
again to re-enable “Talk.”
To enable this opon: 1. Press MENU to enter Menu Mode. From the Main Menu, select “Set Controls,” then “Talk Buons.”
2. Under the “Talk Buons” menu select “Either/Or” and then scroll to “Enable.”

Clear-Com TEMPEST 2400 Specifications

General

Brand	Clear-Com
Model	TEMPEST 2400
Category	Intercom System
Language	English