Climax Mobile Pro - Page 33

30
The duration of Two-way communication is conditioned by the
Two-Way Timer setting.
 Pressing any DTMF key during Two-way communication (except
DTMF 9) will reset the communication time to the preset duration.
 Callback Timer:
 After an alarm is reported to all the reporting destinations and at
least one of them is successful, Mobile Lite will start a waiting period
(callback time) to auto answer any incoming calls.
 When Mobile Lite receives an incoming call within the callback timer,
it will auto answer the call (after the first ring) and wait for the Access
Code (default: 1111) and # key entry within 15 seconds.
 When the correct Access Code is received, Mobile Lite will open a
full-duplex Two-way communication. Use DTMF commands to
switch communication type.
 The Access Code (and the # key) must be entered within 15 seconds
or the system will disconnect the call automatically.
 Press DTMF (9) on Mobile Lite to terminate the call.
 When callback timer is up, the system will automatically exit the
waiting mode and return to idle mode.
 Callback Check Access code:
 When set as “Disable”, Mobile Lite will auto answer an incoming call
within the callback timer and open a full-duplex Two-way
communication without checking the Access Code (default: 1111).
 When set as “Enable”, Mobile Lite auto answer an incoming call
(after the first ring) within the callback timer, and wait for the correct
Access Code (default: 1111) and # key entry within 15 seconds
before it opens a full-duplex Two-way communication. If the correct
Access Code (and the # key) are not entered within 15 seconds, the
system will disconnect the call automatically.
 Auto Check-In Interval:
 You can select the length of the interval between auto check-in
reports.
 There will be no auto check-in report if you select “Disable.”
 Whenever Mobile Lite is programmed, the auto check-in timer will be
reset.
 Auto Check-In Offset:
 After Mobile Lite is rebooted, reset or programmed, the system will
start counting down the time for the first Auto check-in report.