Climax Mobile Pro - Page 34

31
 Mobile Lite will send the first check-in report according to the setting
of Auto Check-In Offset time. Afterwards, Mobile Lite will send
reports according to the setting of Auto Check-in Interval
 Guard Time Sound:
 Select “on” to enable beeps during guard time or “off” to disable the
beeping sound during guard time.
 Confirmation Sound:
 Select “on” to enable confirmation beeps during reporting or “off” to
disable confirmation beeps during reporting.
 Mobile Silent
 When this function is set to “On”, silent mode is turned on where all
sounds are silent.
 When this function is set to “Off”, silent mode is turned off.
 When Mobile Silent is enabled, a Listen-in only communication will
be established initially for Speech Reporting. The call recipient can
enter DTMF keys to change communication types (please refer to
6.5. Alarm Activation for more details).
 Speaker Volume Level
 Adjust the speaker volume of Mobile Lite from a scale of 1-5, where
1 = minimum speaker volume
5 = maximum speaker volume (default)
 Voice Prompt
 Enable: Mobile Lite will play voice prompts accordingly.
 Disable: Mobile Lite will not play voice prompts.
 Answering Incoming Calls:
 Off: Mobile Lite remains silent when there is an incoming call.
 Enable(Ring): Mobile Lite will ring when there is an incoming call.
Press the Active Button to answer the call.
 Enable(Auto-Answer): Mobile Lite will auto-answer an incoming call.
Depending on the setting of “Incoming Call Check Access Code”
(see below), Mobile Lite will check the Access Code or not before it
opens a full-duplex Two-way communication.
 Incoming Call Check Access code:
 When set as “Disable”, Mobile Lite will auto answer an incoming call
and open a full-duplex Two-way communication without checking
the Access Code (default: 1111).