56
SMS Reporting Data Format
ACCT<space>MT<space>QXYZ<space>GG<space>CCC<space>SSSS
ACCT = 4 Digit Account number (0-9, B-F)
<space> = Delimited for ACCT and MT.
MT = Message Type. This 2-digit sequence is used to identify the Contact ID
message to the receiver. It may be transmitted as either 18 (preferred)
or 98 (optional). New receiver implementations shall accept either an 18
or a 98. Note that some older receivers may not accept 98.
<space> = Delimited for MT and Q
Q = Event qualifier, which gives specific event information:
1 = New Event or Opening
3 = New Restore or Closing
6 = Previously reported condition still present (Status report)
XYZ = Event code (3 Hex digits 0-9, B-F)
<space> = Delimited for XYZ and GG
GG = Group or Partition number (2 Hex digits 0-9, B-F). Use 00 to indicate
that no specific group or partition information applies.
<space> = Delimited for GG and CCC
CCC = Zone number (Event reports) or User # (Open/Close reports) (3 Hex
digits 0-9, B-F). Use 000 to indicate that no specific zone or user
information applies.
<space> = Delimited for CCC and SSSS
SSSS = Using the 8-bit Fletcher Checksum Algorithm
The Checksum is calculated up to CCC (including space).
The category to which each event belongs is shown in the brackets following
every event description. The event filter (please refer to 4. Programming
Mobile Lite – SMS Remote Programming for details about the event filter)
will process events according to the categories to which events are assigned.
For example, in the case of “100 – Mobile Lite Emergency (medical)”, “medical”
means the category to which the event “Mobile Lite Emergency” is assigned.
Apart from CID_IP and CSV_IP reporting types, Mobile Lite will report its
current location along with other reports.
Event Codes:
To Next Page
Loading...
