41
HOISTING using a CRANE or SIMILAR
- Position the lifting pipes in the holes on the base of the unit.
- Make sure the ends of the pipes protrude enough to allow the safety pins and split pins to be fitted.
- Position the hoisting straps on the pipes, between the split pins and the base of the unit (see the drawing).
- Place rigid structures on the top edges of the unit to protect it (if one only lifting point is used).
- Gradually tension the lifting straps, checking that they remain in position.
- Start lifting.
Protective
boards
Rigid structure
Hoisting straps
Safety pin
Split pin
Lifting pipes
WARNING
FOLLOWING THE ADVICE ON THE OUTSIDE OF THE CARDBOARD PACKING (IF PRESENT) WILL ENSURE THE UNIT
REMAINS IN PERFECT CONDITION AND OPERATES CORRECTLY, TO THE BENEFIT OF THE END USER. THIS ADVICE
IS AS FOLLOWS:
- HANDLE WITH CARE
- KEEP DRY
- UNDER NO CIRCUMSTANCES EVER PLACE OTHER OBJECTS ON TOP OF THE UNIT UNLESS WITHIN THE
STACKING LIMIT SHOWN (THE NUMBER SPECIFIES THE NUMBER OF STACKING LAYERS.
E.G. 1 = 1 STACKING LAYER PERMITTED ON THE UNIT).
STORAGE
- Store away from: direct sunlight, rain, sand and wind
- Temperature: maximum 60°C minimum -10°C
- Maximum humidity: 90%
REMOVING THE PACKAGING
- Cut the fastening straps with scissors.
- Lift the carton (the protective corner pieces will also slide off).
- Remove the brackets that fasten the unit to the pallet, using a 10mm spanner.
- Lift the unit so that is detached from the pallet.
- Rest the unit on the ground in the chosen position.
- Check for any visible damage.
- Dispose of the packaging so that it is taken to specialist collection or recycling centres (observe the standards in force).
To Next Page
Loading...
Need help?
General