COBHAM EXPLORER 540 - Other M2 M Related AT Commands

Appendix B: Command reference
98-148232-E AT commands 137
Other M2M related AT commands
Parameters for other M2M related AT commands
The table below summarizes the available parameters for the AT commands for M2M
operation.
Command Parameters
_ICLCK
<type>,<enable>,<passwd>
_IMACLOC
<enable>,<interface>[,<interface>]
_IMACLOCAD
<action>,<interface>,<MAC Address>[,<MAC Address>]
a
a. Up to 10 MAC addresses may be specified.
_IPWSAVSCHD
<psmode>,<psvalue>
_ISMSRMT
<enable>
_ITGPIO
<active>
_ITDCIV
No parameters
b
b. Type _ITDCIV? to get the input voltage (in mV) of the EXPLORER 540
Parameter Values Meaning
<action> 0
1
Delete.
Add.
<active> 0
1
Inactive. The GPIO pin is in its inactive state.
Active. The GPIO pin is in its active state.
<enable> 0
1
Disable.
Enable.
<interface> 0 0 means Ethernet interface. This is the only option.
<MAC Address> <MAC Address> MAC address(es) for MAC locking. Up to 10 MAC addresses are permitted.
<passwd> <passwd> The existing administrator password.
<psmode> IDLE_TRG
TOD_TRG
The power save mode to be set up is “idle trigger”, that is the time with no
activity before entering power save mode.
The power save mode to be set up is “time of day”, that is a specific time of
day (UTC time) where the EXPLORER 540 wakes up from power save mode.
<psvalue> <idle-minutes>
<HH:MM>
Used with IDLE_TRG (above). Number of minutes (e.g. 15).
Used with TOD_TRG (above). Time of day in UTC time (e.g. 23:30).