COBHAM EXPLORER 540 - Safety Summary; Keep Away From Live Circuits; Do Not Substitute Parts or Modify Equipment; Keep Away From Antenna Front

98-148232-E iii
Safety summary 1
The following general safety precautions must be observed during all phases of operation, service
and repair of this equipment. Failure to comply with these precautions or with specific warnings
elsewhere in this manual violates safety standards of design, manufacture and intended use of the
equipment. Thrane & Thrane A/S assumes no liability for the customer's failure to comply with
these requirements.
If the equipment is used in a manner not specified by the manufacturer, the protection provided
by the equipment may be impaired.
Keep away from live circuits
Operating personnel must not remove equipment covers, other than the cover for the interface
enclosure. Component replacement and internal adjustment must be made by qualified
maintenance personnel. Do not replace components with the power cable connected. Under
certain conditions, dangerous voltages may exist even with the power cable removed. To avoid
injuries, always disconnect power and discharge circuits before touching them.
Do not substitute parts or modify equipment
Because of the danger of introducing additional hazards, do not substitute parts or perform any
unauthorized modification to the equipment.
Keep away from antenna front
This device emits radio frequency energy when switched on. To avoid
injury, keep a minimum safety distance of 1 m from the antenna front
when the EXPLORER 540 is on.
Garder à l'écart de l'avant de l'antenne
Le présent appareil émet des radiofréquences lors de son utilisation. Afin
d'éviter tout risque pour la santé, une distance minimale de 1 m est nécessaire entre l'utilisateur et
l'avant de l'EXPLORER 540.
Observe marked areas
Under extreme heat conditions do not touch areas of the EXPLORER 540
that are marked with this symbol, as it may result in injury.
C1D2
This equipment is suitable for use in Class I, Division 2, Groups A, B, C and
D OR non-hazardous locations only.
This equipment must be installed using wiring methods as required for Class I, Division 2 as per the
NEC and/or CEC.
WARNING! EXPLOSION HAZARD – Do not connect or disconnect
equipment unless power has been removed or the area is known to be non-
hazardous.