Chapter 3: Operation
98-148232-E To access the terminal from a remote location 27
CLEAR: Delete SMS messages in the EXPLORER 540
The text in the CLEAR SMS must have the following format:
CLEAR <category> SMS <rsms_pwd>
Example: To delete all SMS messages from the EXPLORER 540, send an SMS to the terminal
with the text: CLEAR 4 SMS remote
Response:
No response is sent for this command.
GETINFO: Get information from the EXPLORER 540
The text in the GETINFO SMS must have the following format:
GETINFO <info_mode> {GPS|ALL|USAGE} <rsms_pwd>
Example: To request all information with titles, send an SMS with the text:
GETINFO 1 ALL remote
Response: The response depends on the requested format (GPS/ALL/USAGE) and info mode.
For the command in the example, the response would have the titles shown below.
Example:IMSI: 901112112456789
IMEI: 35393803001003
LAT: 32.89495
LON:-117.20205
SW: 1.0
C/N0: 66
Beam: 84
Uptime: 59483
GIP: 161.30.23.43
The Uptime is in seconds, and GIP is the global IP address of the first active PDP context (BGAN
or cellular, depending on the network in use).
RESTART: Restart the EXPLORER 540
The text in the RESTART SMS must have the following format:
RESTART 1 BGAN <rsms_pwd>
Example: To restart the EXPLORER 540, send an SMS with the text:
RESTART 1 BGAN remote
Response:
No response is sent for this command.
WATCHDOG: Get or set watchdog parameters
Request: The text in the WATCHDOG SMS must have the following format:
WATCHDOG 1 <rsms_pwd>
To Next Page
Loading...
