COBHAM Sailor 900 VSAT - Interfaces of the VMU; Connecting an iNFINITI Series Satellite Router

Interfaces of the VMU
4-8 Chapter 4: Interfaces 98-133966-G1
4.2 Interfaces of the VMU
For interfaces of the VMU and how to connect a VMU correctly to the
ACU see the following sections and the user documentation of the
VMU.
For step-by-step guidelines how to set up the VSAT modem see
Appendix C, VMU settings.
4.2.1 Connecting an iNFINITI® Series
Satellite Router
Connect the VSAT modem to the ACU as shown in the figure below:
For a detailed cable specification for VSAT modems see VMU cables on
page B-1. For step-by-step guidelines how to set up the VSAT modem
see Appendix C, VMU settings.
Figure 4-6: Connecting an iNFINITI® Series Satellite Router
Note
Cable 3 is only used when using OpenAMIP protocol.
5[,Q
7[2XW&RQVROH
/$1%
L1),1,7,6DWHOOLWH5RXWHU
5[2XW
$&8
7[,Q
$QWHQQD
56
$QWHQQD
/$1
  
Cable Description Cable specifications
1 RX Out to Rx In 75 Ohm coax cables F-F (1m), included
2 RS-232 to
Console
3 LAN 1 or 2 Standard Ethernet cable
4 Tx In to Tx out 75 Ohm coax cables F-F (1 m), included
Table 4-8: Cables to connect an iNFINITI® Series Satellite Router
96$7PRGHP
*1'
6LJQDOSRZHU


56RQ$&8




SAILOR900TM.book Page 8 Monday, September 16, 2013 11:01 AM