98-133966-G1 6-1
Chapter 6
6666
Configuration
Configuration 6
This chapter is organised in the following sections:
• Introduction to the built-in web interface
• Calibration of the SAILOR 900 VSAT
• Configuration with the web interface
• Keypad and menus of the ACU
• SNMP support
6.1 Introduction to the built-in web
interface
6.1.1 Overview
Use the built-in web interface of the SAILOR 900 VSAT ACU to make a full
configuration of the SAILOR 900 VSAT with the correct VMU, the satellite
positions you intend to use and other parameters.
Connect the LAN cable to LAN 3 on the rear panel or the front LAN
connector of the ACU.
For quick start instructions see Calibration of the SAILOR 900
VSAT on page 6-3.
No installation of software is necessary. The web interface is built into the
SAILOR 900 VSAT ACU. You access the web interface from a computer with
a standard Internet browser.
6.1.2 Connecting to the web interface
To connect to the web interface of the ACU do as follows:
1. Power up the SAILOR 900 VSAT system, i.e. switch on the ACU. Wait until
the LEDs on the front plate of the ACU show that the system is ready to
be configured.
• Power LED: Green
• Logon LED: Off
• Fail/Pass LED: Flashing green, during power-on self test, after that
steady green.
2. Connect a PC to LAN interface 3 (Service port, standard Ethernet) of the
ACU or to the front LAN connector of the ACU.
SAILOR900TM.book Page 1 Monday, September 16, 2013 11:01 AM
To Next Page
