Calibration of the SAILOR 900 VSAT
98-133966-G1 Chapter 6: Configuration 6-5
6666
Configuration
LNB: Co-pol or X-pol, use this for test if both the LNBs and RX cables
function properly in case of issues with the reception of a signal. The
polarisation must remain the same as stated for the transponder used
for the azimuth calibration. The antenna will just turn the polarisation
motor 90 degrees to use the other LNB to receive the same signal.
4. Click Apply to save the settings for the service profile for calibration.
The system is ready for the azimuth and cable calibration.
6.2.2 Vessel heading & calibration of azimuth
and cable
Access the page for heading and calibration through SERVICE >
Calibration.
Figure 6-4: Web interface: SERVICE, Calibration
Note
If you do not want to enter the satellite data on the calibration page
you can set up a dedicated service profile for calibration, see 6.2.1.
Check that the satellite transponder is visible from the location of the
installation and at an elevation angle between 10 and 70 degrees.
SAILOR900TM.book Page 5 Monday, September 16, 2013 11:01 AM
To Next Page
