USER MANUAL
4. Click one of the
Setup
icons to configure the detection conditions.
Switch
: Activate or inactivate the detection.
Type: Choose the detection target objects. Motion will detect all moving objects, Person will
detect human beings only, Vehicle will detect vehicles only.
Sensitivity
: Set the sensitivity level. Level 1 the lowest sensitivity level while level 4 is the
highest sensitivity level.
Rule Type
:
A
B:
If a target object is detected moving from side A to side B, the system will count 1 to
enter number; if a target object is detected moving from side B to side A, the system will
count 1 to exit number.
B
A:
If a target object is detected moving from side B to side A, the system will count 1 to
enter number; if a target object is detected moving from side A to side B, the system will
count 1 to exit number.
Start Time
: Set the detection start time.
End Time
: Set the detection end time.
Dynamic Marking：If you enable this option, the border of the detection zone will be
displayed in both live view images and recording files.
Configuration Steps
:
i. Activate the
Switch
.
ii. Choose the detection target type.
iii. To set the
Sensitivity
.
iv. Choose a
Rule Type
.
v. Set the
Start Time
and
End Time
.
vi. Use your mouse to click 2 points in the camera picture to draw a virtual line.
vii. Click
Save
to save your settings.
viii. If you want to modify the position or length of the line, click the red box in the
line, the color of the line will be changed to red color. Click and hold the left
To Next Page
Loading...
