USER MANUAL
ETR
: setting different streams for normal and alarm recording.
In the
Audio
section, you can define the input/output volume, and encode type of the audio.
5.2.2 Record
This menu allows you to configure the channel recording parameters.
5.2.2.1 Record
Record Switch
: Check to enable the recording in this channel.
Stream Mode
: Choose the recording quality. If you choose Dualstream, the system will
record in both Mainstream & Substream.
PreRecord
: If this option is enabled, the NVR starts recording a few seconds before an
alarm event occurs. Use this option if your primary recording type is motion or I/O alarm
based.
To Next Page
Loading...
