Cobra 57648 - Chapter 4 NVR Starting up; Start Wizard; Network Configuration

USER MANUAL
6
Chapter 4 NVR Starting up
4.1 Start Wizard
Startup Wizard will help to configure the system and get the NVR works quickly.
4.1.1 Start Wizard
Click the
Start Wizard
to proceed to the next step
4.1.2 Network Configuration
If you connect to a router allows to use DHCP, please check the
DHCP
box. The router will
assign automatically all the network parameters for your NVR. Unless the network is
manually addressed below parameters:
IP Address
: The IP address identifies the NVR in the network. It consists of four groups of
numbers between 0 to 255, separated by periods. For example, “192.168.001.100”.