USER MANUAL
5.1.7 PIR
This menu allows you to configure PIR parameters. When PIR has been detected
by one or more cameras, your NVR will alert to you a potential threat. It does this by sending
you an email alert with an attached image from the camera to use as a reference (if this
option is enabled) and/or sending push notifications via the mobile app.
Setup
: Click icon into the setup page.
Switch
: Enable or disable PIR detection.
Sensitivity
: Set the sensitivity level. Level 1 the lowest sensitivity level while level 8 is the
highest sensitivity level.
PIR Detection Area:
The whole screen is marked for PIR
detection (red blocks) as default. If you
want to disable the PIR detection on a
certain area, click the grid cursor and
then drag the mouse to highlight the
scope to unmark the area into
transparent blocks. After setting is
completed, click the right button of your
mouse to return and click Save to make
the area setup effective.
To Next Page
Loading...
