Cobra 57648 - SOD (Stationary Object Detection)

USER MANUAL
40
Note:
1) The lines shall not be too close to the edges of the camera picture, to avoid any failure to
trigger an alarm when the target cross through it.
2) The lines shall not be set too short, to avoid any failure to trigger an alarm when the target
passes outside it.
For Alarm setup, please refer to
5.1.9.1.1 Alarm Setup
5.1.9.3 SOD (Stationary Object Detection)
Stationary Object Detection function detects the objects left over or lost in the pre-defined
region such as the baggage, purse, dangerous materials, etc., and a series of actions can be
taken when the alarm is triggered.
Switch:
Check the box to enable SOD function.
Sensitivity
: Set the sensitivity level. Level 1 the lowest sensitivity level while level 4 is the
highest sensitivity level.
Click
Setup
icon to draw a virtual region in the camera image.