USER MANUAL
5.8.1.2 Group View Setup
1. Click the add icon or setup icon to get to the configuration page.
2. Click the
Add IP Camera
icon to add channel(s) to the group. Max. 8 groups can be
set, but each one channel can be added to 1 group only. If a channel is enabled in the
Channel View mode, it will be not allowed to add to any group.
3. Check the Enable box to activate the group.
4. Set the
Capacity
number,
Start Time
,
End Time
of each group.
5. Choose the detection target
Type
from
Person
,
Vehicle
and
Motion
.
6. Click one of the
Alarm
icons to configure the alarm actions when the Available
number is 0.
Buzzer:
Set the buzzer duration in seconds when the Available number is 0.
Alarm Out
: If your NVR support to connect to external alarm device, you can set to emit an
alarm tone.
To Next Page
Loading...
