Cobra 57648 - Page 55

USER MANUAL
44
Channel
: Select the channel you want to configure
Rule Number
: Max. 4 rules available.
Rule Switch:
Activate or inactivate the rule
1.
To enable the detection in
Rule Switch
.
2.
Choose a
Rule Type
.
A

B:
If a target object is detected moving from side A to side B, the system will count 1
to enter number; if a target object is detected moving from side B to side A, the system
will count 1 to exit number.
B

A:
If a target object is detected moving from side B to side A, the system will count 1
to enter number; if a target object is detected moving from side A to side B, the system
will count 1 to exit number.
3.
Use your mouse to click 2 points in the camera picture to draw a virtual line.
4.
Click
Save
to save your settings.
5.
If you want to modify the position or length of the line, click the red box in the line, the
color of the line will be changed to red color. Long press the left button of your mouse to
move the line, or drag the terminals to modify the length or position of the line.
6.
If you want to remove one of the lines from the camera picture, click the red box in the
line and then click
Remove
button. Click
Remove All
will delete all lines.
For Alarm setup, please refer to
5.1.9.1.1 Alarm Setup