Codan HF SSB series - Receiving Beacon Calls

Receiving calls
HF SSB transceiver user guide 5-11
Receiving beacon calls
When your transceiver receives any type of beacon call, it
takes a few seconds to respond automatically and send the
beacon revertive signal to the station that sent the beacon
call.
You can recognise that you are receiving a beacon call if you
observe your transceiver:
• temporarily pause from scanning
• tune the antenna (if your station has an automatic tuning
antenna)
• show
Tx
on the display.

Receiving calls
HF SSB transceiver user guide 5-11
Receiving beacon calls
When your transceiver receives any type of beacon call, it
takes a few seconds to respond automatically and send the
beacon revertive signal to the station that sent the beacon
call.
You can recognise that you are receiving a beacon call if you
observe your transceiver:
• temporarily pause from scanning
• tune the antenna (if your station has an automatic tuning
antenna)
• show
Tx
on the display.
