To Next Page

To Previous Page

Using the transceiver

HF SSB transceiver user guide 3-39

Customising your transceiver

Now you are ready to customise your transceiver so that it

can operate efficiently within your network. This section will

help to get you started.

Once your station is up and running, you may want to change

other settings and further customise your station.

To get an idea of the general operational settings you can

change, refer to the HF SSB transceiver reference manual,

Chapter 3, Channel and scan table setup, and Chapter 4,

Using Setup mode procedures. Many of these settings you

will never need to change since they have already been set up

to suit the most common user.

To find out what settings you need to make to be able to send

and receive each type of call, read the descriptions for each

call type in Chapter 4, Sending calls.

General transceiver operation

You will probably want to:

• set the clock (refer to the HF SSB transceiver reference

manual, Chapter 5, Clock setting)

• reset the clock calibration to its middle position (refer to

the HF SSB transceiver reference manual, Chapter 5,

Clock calibration)

• set up a scan table so that you can scan for incoming calls

on more than one frequency (refer to the HF SSB

transceiver reference manual, Chapter 3, Scan table

creation).