To Next Page

To Previous Page

Using the transceiver

HF SSB transceiver user guide 3-37

Using View All Settings mode

View All Settings mode allows you to view the settings that

control transceiver operation.

You can view the following information (the items displayed

depend on which transceiver options are fitted in your

transceiver):

• number of channels set up in the transceiver and enabled

options

• time and date

• transceiver software issue

• control panel (front panel) software issue

• your transceiver ID (identification code)

• automatic scanning, selcall mute, 4-digit address

compatible

• selcall groups S1–S5 holding your address

• address of station to call in an emergency selcall

• emergency selcall transmit channels

• emergency selcall receive

• 99-beacon, telcall, selcall lockout

• tone call groups T1–T4

• recall by frequency, beep loudness

• PTT timeout, PTT beeps

• RS-232 mode, RS-232 baud, GPS timeout

• antenna band/channel, RF gain

• PA frequency range (your transceiver’s transmitting

frequency range).