Codan HF SSB series - Selcall

Sending calls
4-26 HF SSB transceiver user guide
Selcall
A selcall is the basic type of selective call.
You can send selcalls simultaneously to a range of stations by
group calling.
Before you can send a selcall, you need to set up:
• your address (refer to the HF SSB transceiver reference
manual, Chapter 8, Selcall address setup)
• a channel for selcalling (refer to the HF SSB transceiver
reference manual, Chapter 3, Channel creation and
editing)
To send a selcall:
Action Notes
1.
To find a good channel
to use, send selective
beacon calls on the
frequencies scanned by
the other station.
See Selective beacon call on
page 4-29.
2.
In Channel mode, select
the best channel and
wait until the channel is
clear of all voice and
data traffic.
Sending calls
4-26 HF SSB transceiver user guide
Selcall
A selcall is the basic type of selective call.
You can send selcalls simultaneously to a range of stations by
group calling.
Before you can send a selcall, you need to set up:
• your address (refer to the HF SSB transceiver reference
manual, Chapter 8, Selcall address setup)
• a channel for selcalling (refer to the HF SSB transceiver
reference manual, Chapter 3, Channel creation and
editing)
To send a selcall:
Action Notes
1.
To find a good channel
to use, send selective
beacon calls on the
frequencies scanned by
the other station.
See Selective beacon call on
page 4-29.
2.
In Channel mode, select
the best channel and
wait until the channel is
clear of all voice and
data traffic.