To Next Page

To Previous Page

Advanced features

HF SSB transceiver user guide 6-13

Using more than one control panel

You can control the transceiver from more than one control

panel if you have connected one or more control heads to

your system.

The operating mode of the connected system, identified as

Multi-Access or Single-Access mode, is determined

automatically according to which of the transceiver functions

listed below is being used.

Emergency calls are not affected by operating modes. You

can send an emergency call from any control panel at any

time.

Multi-Access mode

When the transceiver is in Multi-Access mode, you can use

any control panel to control the transceiver. The displays on

all control panels are the same.

Multi-Access operating mode functions include:

• PTT voice calls

• scanning

• Channel mode when not calling

• Clarifier mode when not calling

• Free-Tune Receiver mode

• View Channel Options mode.

If you operate between control panels, you need to wait two

seconds before controlling the transceiver from the new

panel.