Codan HF SSB series User Manual

Using the transceiver
HF SSB transceiver user guide 3-31
Using View Channel Options mode
View Channel Options mode allows you to view the channel
settings of any channel. To change channel settings, refer to
the HF SSB transceiver reference manual, Chapter 3,
Channel creation and editing.
If you do not touch any button or knob for 30 seconds while
in this mode, the transceiver automatically returns to Channel
mode.
The table below describes the channel settings.
This setting... Means...
U Upper sideband.
L Lower sideband.
LU Lower or upper sideband selectable.
NP Not Protected. You can edit or delete this
channel.
P Protected. Apart from changing the
channel comment, you cannot edit or
delete this channel.
S– You cannot send selcalls on this channel.
S1 Channel uses selcall group 1 settings.
S2 Channel uses selcall group 2 settings.
S3 Channel uses selcall group 3 settings.
S4 Channel uses selcall group 4 settings.
S5 Channel uses selcall group 5 settings.
T– You cannot send tone calls on this
channel.
T1 Channel uses tone group 1 frequencies.
T2 Channel uses tone group 2 frequencies.
T3 Channel uses tone group 3 frequencies.
T4 Channel uses tone group 4 frequencies.
Using the transceiver
HF SSB transceiver user guide 3-31
Using View Channel Options mode
View Channel Options mode allows you to view the channel
settings of any channel. To change channel settings, refer to
the HF SSB transceiver reference manual, Chapter 3,
Channel creation and editing.
If you do not touch any button or knob for 30 seconds while
in this mode, the transceiver automatically returns to Channel
mode.
The table below describes the channel settings.
This setting... Means...
U Upper sideband.
L Lower sideband.
LU Lower or upper sideband selectable.
NP Not Protected. You can edit or delete this
channel.
P Protected. Apart from changing the
channel comment, you cannot edit or
delete this channel.
S– You cannot send selcalls on this channel.
S1 Channel uses selcall group 1 settings.
S2 Channel uses selcall group 2 settings.
S3 Channel uses selcall group 3 settings.
S4 Channel uses selcall group 4 settings.
S5 Channel uses selcall group 5 settings.
T– You cannot send tone calls on this
channel.
T1 Channel uses tone group 1 frequencies.
T2 Channel uses tone group 2 frequencies.
T3 Channel uses tone group 3 frequencies.
T4 Channel uses tone group 4 frequencies.

Codan HF SSB series Specifications

General

Brand	Codan
Model	HF SSB series
Category	Transceiver
Language	English